Skip to main content

Filter By:

  • Show More Brands

  • Show Fewer Brands

Other

OneUp Components Dropper Remote Clamp 22.2mm Handlebar -V2
$16.50
V2 dropper remote clamp for 22.2mm handlebar.
OneUp Components Dropper Rebuild Kit - V2
$17.99
This kit includes all the parts required to rebuild your V2 Dropper Post. - Replacement Seal - Upper and lower bushings - Anti-rotation pins - Compatible with V2 Dropper Post ONLY.
OneUp Components Dropper V2, Oversized Pin Kit
$17.99
Set of six oversized pins. All dropper posts require key way clearance. With so many different frames, clamps and ride heights it's not possible to ship play-free without running the risk of binding. The kit is meant to remove additional play that might develop over time or, for the more mechanically inclined, to tune the play out for a specific bike. Start with the 3 pins marked with 2 lines. If play still exists move to the 3 pins marked with 4 lines.
OneUp Components Dropper Remote Clamp SRAM MMX - V2
$25.00
Replacement dropper post remote clamp. Can be used to convert existing clamp on the OneUp Dropper Remote. - Compatible with SRAM MatchMakerX (MMX) or Shimano I-Spec EV (M9100) brake mounts. - Does not contain remote body.
OneUp Components EDC Top Cap
$29.00
The EDC Cap Kit includes the worlds lightest headset top cap (4.2g), and an EDC steerer plug with drain hole which keeps crud out of your steerer. Top caps are compatible with all 1-1/8" aluminum steerer tubes. The EDC steerer plug is required for EDC tool storage and is compatible with most aluminum tapered steerer tubes. KIT INCLUDES - EDC TOP CAP - EDC steerer plug - 2x 1mm, 3mm, & 5mm Headset Spacers
OneUp Components Dropper Post Remote - V2 - SRAM MMX
$69.00
A BETTER REMOTE FOR ANY CABLE OPERATED DROPPER An Aluminum remote with an oversized bearing and a super smooth action. The unique lever position allows you to keep a stronger grip on the bars while actuating your post. Don't think twice about dropping your post, even when charging into technical sections. The OneUp lever mimics your R/H shifter’s inboard upshift paddle position instead of the usual downshift paddle position of most remotes. This position requires considerably less thumb movement to reach the lever. NO BLEEDING The cable setup is quick and easy. The cable clamps at the lever making shortening the housing length for clean routing a breeze. Unlike a hydraulically actuated dropper, there is no temperature sensitivity and If your remote gets damaged you can still lower or extend your post by removing it from your frame and pushing on the actuator by hand. - Kit includes cable and housing - Compatible with all cable actuated dropper posts.
Page 1 of 1